Error | "Block processing not supported on this model Core"

Learn how to troubleshoot a core error when block processing is not supported.

Updated at May 22nd, 2023

Affected Products

Hardware Model/Series N/A
Software QDS when Check Design

Message

"Block processing not supported on this model Core" from Check Design.


Definition

This message can be an indicator that the Maximum DSP Property for the Core has been set to "No".  A verification of this will be shown by Category 1 Processing only being shown as available in Check Design.


 

Solution | Workaround

If there are no Category 2 processing blocks in the design (AEC, NFC), this message will not display.  The message is thus an indication that both types of processing are required by the design, however the Property to enable such has not been selected.

For further information, look under the Properties/Core Properties section of Status (Core) in the Q-SYS Design Help.