How To | Wiring WCP-1 to the GPIO Input on a Q-SYS device
Learn how to connect a WCP-1 to the GPIO input on a Q-SYS device for efficient operation.
Procedure
The best way to wire the WCP-1 to Q-SYS devices (Core 110f, Core 8 Flex, I/O 8 Flex, or NV-32-H) is to use 3 wires:
- The CW pin is wired to the +12VDC screw
- The CCW pin is wired to the GND screw
- The W pin is wired to the GPIO Input screw
Make sure to set the GPIO Input type as "Potentiometer (10k ohm, 12v)”. See the diagram below.